Traps can be very useful in water warfare. It can sometimes be hard to defend your base. Traps can help in these situations. In this article, I will go into detail on how to make traps and where to put them.

Water Balloon Mines

Water Balloon Mines are very useful; they get your opponents wet. Although they only get your get their feet they still prove their uses on the battlefield. Be catious thought, while running if a person trips in in the whole serious injury can occur.

Assembling

Water balloon mines are simple to construct. I will tell you how in this step to step guide below:

1) Fill up one water balloon.
2) Dig a hole about 3/4 the size of the balloon.
3) Carefully place the balloon in the hole.
4) If you want you may camouflage the hole with leaves, sticks, and grass.

^ A water balloon mine placed in my backyard

Placement

You should place water balloon mines at the entrances of your base and also consider putting them inside of your base.

Trip Wire Alarms

Trip Wire Alarms can often be useful to give you a warning that the enemy is near. They can also help you find the enemies location.

Assembly 1

Trip Wire Alarms are simple to construct. I will tell you how in this step by step guide below:

1) Get the needed supplies: floss or fishing wire, 2 sticks, noise maker, carving knife.
2) Get the carving knife and make a wide slit on the top of the sticks.
3) Make the noise maker (about 20 pennys in a tin can works well).
4) Tie the floss/fishing wire to the noise maker.
5) Thread the floss/fishing wire through the slits.
6) Post in suitable area.

Assembly 2

1) Get the needed supplies: floss or fishing wire and 2 noise makers.
2) Make the noise makers (about 20 pennys in a tin can works well).
3) Tie the floss/fishing wire to the noise makers.
4) Place on ground.
5) If you want, you may camouflage the hole with leaves, sticks, and grass.

Placement